NRG Heated Mirror for backlit bathroom mirror

For permanent mist free mirrors, simply stick one of our self adhesive heating pads to the backlit bathroom mirror & connected to the lighting circuit.
Our NRG heated mirrors are suitable for direct application to a mirror and connected to a suitable lighting circuit or its own power supply.

Voltage: 230V A/C
IP: 44
Fitting your heated mirror

1.     Mark out the backlit of bathroom mirror to indicate where the heating pad is to be fitted

2.     Peel off the protective paper exposing the 'sticky' side

3.     Position one edge of the heated mirror  in the desired position on the keeping the other edge away from the mirror

4.     Gradually lower the pad onto the mirror applying even pressure to ensure there are no air bubbles or creases

5.     If the mirror is not framed & is being fitted directly onto the wall, a small recess will need to be made in the wall to compensate for this & allow the mirror to sit flush.

Electrical Connections

All wiring must conform to the latest IEE wiring regulations ( BS7671 equivalent) if in doubt always consult a qualified electrician.

1.     It is recommended that the heated mirror is connected via the lighting circuit or on a separate switch.

2.     The circuit should be protected by a 5amp fuse or circuit breaker

3.     The wires are coloured as follows: BLUE - Neutral, and BROWN - Live/positive

4.     The heating pad must not be accessible once installed

5.     Any metal part surrounding the mirror must be earthed & comply with current wiring regulations

6.     Multiple heated mirror may be fitted to a single mirror & should be connected in parallel - pads must not overlap

The NRG heated mirror must not be cut or pierced as this may damage the insulation making it unsafe.